Open Closed Valley Roof

An open roof valley meanwhile is a flashing method in which a sheet of pre bent metal is installed after the valley lining is placed.

Open closed valley roof.

It is always a good idea to check with the manufacturer or a certified installer of the product such as ourselves. Part of the underlayment includes a self adhering ice and water shield that a heavier gauge than the rest of the underlayment. A roof valley is formed where two roof slopes meet. The self adhering section acts as the lining for the valley.

After the self adhering underlayment is installed across the valley a pre bent metal valley lining is installed. Water collects in a valley to flow off the roof. The closed variation is a flashing that has been completely covered with shingles while in the open variation will have the flashing completely exposed to the elements. Since the area is covered by shingles the closed valley makes the roofing system more appealing when seen from the ground.

Woven closed cut and open. The metal is usually pre painted to best complement the shingles color blend. Closed valley before you install a shingle roof the contractor will install an underlayment over the entire roof deck. About open roof valleys.

Roofing shingles are installed then cut and sealed where they overlap the metal channel. In comparison to a closed valley an open valley adds another layer of lining into the valley. This leaves a metal strip or line on the surface of the roof that serves as the valley line. This valley flashing material can be manufactured from any metal that will resist the effects of weather acid rain and other contaminants.

For an open valley a sheet of metal usually steel sometimes copper is fastened to the roof deck. If you have a shingled roof as most torontonians with a sloped roof tend to have then you will have one of two kinds of valleys on your home. Open roof valley this is almost the same as the closed roof valley method except a pre bent metal valley lining is installed instead of a secondary roof underlayment. The only type of valley that is unacceptable is the woven valley.

Once the shingles are installed they don t run through the valley area. An open valley has a gap usually about 6 inches between the tile or shingles at the valley area. The roofers apply the shingles cutting and sealing the ones that overlap the metal. Although the open valley is recommended by the manufacturer closed valley is acceptable.