Osha Roofing Safety Regulations

Except as otherwise provided in paragraph b of this section each employee engaged in roofing activities on low slope roofs with unprotected sides and edges 6 feet 1 8 m or more above lower levels shall be protected from falling by guardrail systems safety net systems personal fall arrest systems or a combination of warning line system and guardrail system warning line system and safety net system or warning line system and personal fall arrest system or warning line system and.

Osha roofing safety regulations.

Construction safety orders sections 1500 1962 subchapter 5. Cal osha safety health. Since roofs rarely have any sort of built in protective rails employers must provide fall protection for roof workers. And subchapter 7 general industry safety orders.

Electrical safety orders sections 2299 2974. Subchapter 5 electrical safety orders. Construction workers engage in many activities that may expose them to serious hazards such as falling from rooftops unguarded machinery being struck by heavy construction equipment electrocutions silica dust and asbestos. Construction employers must comply with cal osha regulations found in the following subchapters of california code of regulations title 8 chapter 4.

Osha requires fall protection for workers on surfaces over six feet off the ground that do not have protection along the surface edges. California occupational safety and health regulations. Below is a table of frequently cited osha standards for roofing contractors during fy 2013. Subchapter 4 construction safety orders.

Construction is a high hazard industry that comprises a wide range of activities involving construction alteration and or repair. Protecting roofing workers osha 3755 2015 english. Osha requires that anchors for pfass be able to hold at least 5 000 pounds of weight per person or maintain a safety factor of at least two twice the impact load under the supervision of a qualified person. Lay headers sheets of roofing or other materials no closer than 5 feet inside the edges of the roof and parallel to the roofline.

When the fall protection measures listed above are not used mark the edges of the flat roof with headers and warning lines to notify workers of potential fall hazard areas using the following guidelines. Osha enforces its regulations and standards by conducting inspections based on priority such as an imminent danger situation fatality or a worker complaint. Cal osha guidance for construction employers. Regulations of the director of industrial relations sections 330 339 11.

Reducing falls during residential construction.